Many anglers will confirm how exciting fishing is on the feeder. During the course, excitement doubles, since it gives the opportunity to this gear to show its potential to the end.
The fast stream, which sometimes interferes with holding the feeder in place, nevertheless also provides a service by distributing lure, which makes it possible to attract fish from the largest possible water area.
However, fishing on the feeder is not always easy . On a course that is very strong, you need to use feeders weighing more than eighty grams. And if with an average flow there are practically no problems with complementary foods, since it does not drift and is always delivered to the same place, then at high water speeds it can be much more difficult to achieve this, even knowing all the features of this type of fishing.
But even on very fast channels there are places where the current is much weaker. These can be places with a reverse stroke, bays, whirlpools, turns. All of them can be very catchy, since most of the fish fishing on the feeder do not feel very well during the course. And this is not surprising, because in this case they need to make a lot of efforts to withstand the flow of water, with a strong jet it is more difficult to find food.
It is not always possible to find places where the current will be at least average, so you have to be content with what you have. The most common difficulty that a fisherman encounters is elevation changes and feed loss. And many prefer to abandon such a not so "quiet" hunt.
However, there are anglers for whom fishing with feeders in strong currents is not a problem. They know several ways to keep food complementary. The first is the change in weight of the feeder, which is achieved mainly by adding a weight. In addition, a thinner fishing line is used. But there is another method: raise the feeder as high as possible so that the minimum amount of fishing line is in the water.
Some anglers say that catching on a feeder, on stream or in still water, will be successful if triangular feeders with bottom hooks are used.
In addition, you need to know that for each type of prey for this type of fishing you need to take a special bait. For example, catching a bream on a feeder, especially during the course, implies a complete rejection of such complementary foods, which even have a small dusty fraction. The mixture, falling into the water, should lay down in a dense layer, without rising and not drifting down the train. Otherwise, the bait table will be smeared and will attract many small fish.
The bream is an extremely sensitive prey, preferring an abundance of crackers or an active biscuit, as well as sticky large fractions, which, with their properties, will allow the fish to spin around, rummage and choose a favorite treat, which can be bought at any specialized store today.
For fishing on the bream, you can use different montages. This can be an asymmetric loop, and a helicopter, two nodes, and so on. However , according to experienced fishermen, the optimal feeder gear for fishing along the course of not only bream, but also other fish is a paternoster.