Today in this article we will look at how to set up a network between two computers. You may have already tried to do something similar. The article will describe the simplest method for performing this operation. It should immediately be said that you do not have to have any in-depth knowledge. It is simple enough to carry out all the steps of the instruction in order. So, then you will learn how to set up a network between two computers.
Training
This method uses only one component. Namely - “twisted pair”. This cable is very inexpensive, and it can be purchased at any specialized store. As a rule, its minimum length is approximately 1.5 m and can reach 90 m. First of all, you need to purchase such a cable. Also, in order to create a network between two computers, a network card must be installed in both PCs. All components can be purchased at any electronics store. If all the elements are available, then you can begin to consider the instructions themselves.
Instruction manual
Turn on both computers and connect them using a cable. The ends of the wire must be connected to the network card. After these steps, a new local network will appear on both PCs . Now you need to make some of its settings:
- Go to the “Control Panel” - open the “Status View Window ...” - “Change adapter settings”.
- Here you will see a window where all the connections that are currently in the active state will be indicated.
- You need to select “Local Area Connection”. Right-click on the shortcut, then select “Properties”. If you have several of them, in most cases you need to choose the connection, which will have a figure with a higher face value after the name.
- Find the “Internet Protocol Version 4 (or 6)” option. Select it and click the "Properties" button.
- Enter the new IP address in the format 192.168.XX The first two values always remain unchanged. The last two can be changed as you wish. It is recommended not to use those IP addresses where the values end with the numbers 1 or 2, since they are used by standard means.
additional information
You previously learned how to set up a network between two computers, but in some situations you may need to connect more than two devices. In such cases, you can not do with just one cable. You will need to purchase a special router. This device allows you to distribute the network between multiple PCs. In this case, the number of connected computers is limited by the number of slots on the router. It is possible to use several such devices at once to connect more PCs.
Conclusion
There is nothing complicated in making a network between two computers. As you can see, you will need minimal investment and a little time to set up the system. The main thing is to check that the network cards of computers are working before starting the connection. This can be done through the standard device manager tool. If the board is listed, then everything is fine. I hope you understand from this article how to set up a network between two computers.