All vehicles are equipped with gauges and locking sensors. They serve to control the operation of the engine and other important systems. The VAZ-2107 torpedo is no exception. The driver can prevent the failure of the nodes if he timely responds to the readings. Consider the features of the panel of a domestic machine, the possibilities of its improvement and other features.
Designations
The VAZ-2107 torpedo is an important component of the entire structure. The dashboard diagram is as follows:
- Vehicle voltmeter.
- Speedometer indicating speed reading.
- Odometer (mileage indicator of the car).
- Accounting device showing the crankshaft speed. Its technical name is the tachometer. The screen has several zones painted in different colors. The yellow compartment is the engine running at high speeds, the red part is unacceptable modes. The maximum revolutions of this machine is 6 thousand rotations per minute.
- Refrigerant status temperature gauge. If the arrow is in the green zone, this is the norm. Overheating of the power unit is accompanied by a mark in the red part of the indicator. If the coolant temperature exceeds 118 degrees Celsius, it is strongly not recommended to operate the car.
- Index of economical operation of the motor (econometric). His arrow should be in the green zone.
- Vehicle warning lamp assembly.
- Activation of repeated signals (turns).
Other pointers
The VAZ-2107 torpedo has a number of signaling devices. Among them:
- Sensor for malfunctioning engine control (relevant on models with fuel injection system). The indicator lights up in orange color when the ignition is on. After starting the power unit it goes out. If the light flashes frequently and is constantly on, contact a repair shop. The operation of the machine is allowed, the system goes into standby mode.
- Battery charge signal. When the motor starts, the indicator lights up in red and turns off. If the lamp continues to glow, pay attention to the battery charge. The main causes of the malfunction: poor timing belt tension, malfunction of the generator or a fault in the electrical circuit. If you ignore this problem, it will lead to a complete discharge of the battery, and in some cases to a fire.
- Marker light (when switched on, lights up in green color).
Additional indicators
The VAZ-2107 torpedo, the photo of which is presented above, has several more important indicators, namely:
- Headlight High Beam Activation Sensors. The lamp lights up in blue.
- Oil pressure controller. If this indicator is sufficient, when the motor is turned on, the indicator glows red and immediately goes out. A long glow indicates a low oil pressure. Ignoring this problem can lead to failure of the vehicle power plant.
- Parking brake control mode (its inclusion is indicated by the corresponding lamp, which lights up red after starting the motor).
- The indicator of the mileage traveled per day.
- Fuel gauge. If about 5 liters of fuel remains in the tank, it lights up yellow.
- The main indicator of gasoline level.
Key Type Switches
The overlay on the dashboard VAZ-2107 has special sockets for key switches. Among them:
- The controller of external lighting. It has three positions. The first indicates that the system is deactivated, the second - the inclusion of illumination lamps of license plates and dimensions, the third - the inclusion of dipped beam.
- Automatic rear window defogger. You can turn it on after starting the motor.
- Car rear fog light switch. The controller is activated simultaneously with the dipped headlights.
- Heater fan regulator. With it, you can select the desired speed of circulation of air supplied by the heater.
In addition, the VAZ-2107 torpedo is equipped with alphanumeric control indicators, namely:
- Signaling device "A" indicates unfastened seat belts (glows red when the ignition is turned on).
- “B” - lights up in orange, signals the operation of the rear window heating.
- “B” - emergency operation indicator of the brake unit of the machine. Lights up in red if a critical decrease in the fluid level in the reservoir of the hydraulic brake actuator occurs.
Reasons for the tanning of emergency indicators
Tuning a torpedo VAZ-2107 involves the best exterior design and original lighting. But the overall functionality is preserved in a traditional style. Among the most common emergencies, the following points are noted:
- If the oil pressure level sensor illuminates, shut off the engine. Then you need to check for oil, add if the level is below acceptable. A further glow of the indicator indicates that it is required to tow the machine to a service station or other repair place. When ignoring the problem, situations are possible when there is a knock of the connecting rods of the motor and further jamming of the unit. This is fraught with replacing the engine or carrying out its overhaul.
- If the battery warning light is on, check the terminals for a secure fit and oxidation. The second reason the sensor is triggered is a malfunction of the generator. It is advisable to disconnect all electrical devices and visit the nearest repair station. A good battery, even in such conditions, can work for about 100 kilometers if the power is supplied exclusively to the ignition system. Typically, a problem occurs due to a breakdown of the voltage regulator.
- The VAZ-2107 torpedo on the VAZ-2106 has the same characteristics as in the standard version. For example, if the emergency brake fluid sensor lights up, you must immediately shut off the engine and stop. Then you need to check the fluid level, add it if necessary. If the brake system does not work, you must call the tow truck and consult a repair specialist.
What else to look for?
Some dashboard indicators also require special attention. For example, if the liquid boiling indicator is in the red zone, you must literally immediately stop the machine and allow the motor to cool. Given that in the early versions of the Lada such a sensor is not provided, the novice driver may not notice this moment. But the problem, as a rule, is accompanied by the release of steam from under the hood. It is worth noting that you should not immediately touch the working parts of the engine, since you can get very burned. Most often, a malfunction occurs due to insufficient refrigerant, breakdown of the thermostat or radiator fan. Specialists of service stations or skills of owners who are not the first year behind the wheel will help to solve the problem.
The fuel level indicator signals its minimum supply by turning on the red light. This happens if less than five liters of fuel remain in the tank. The problem is solved simply - you need to refuel the car at the nearest gas station. In addition, you need to pay attention to the parameters of the tachometer. Holding the arrow of the device in the green zone (not more than 5 thousand revolutions per minute) allows you to provide the most economical driving mode.
How to remove a torpedo on a VAZ-2107?
This operation consists of several main steps:
- The car is being prepared for the initial stage (these manipulations are in the vehicle maintenance and repair instructions).
- The negative terminal of the battery is disconnected.
- Using a screwdriver or similar tool, the handle block from the heater control levers is pried out.
- Then, the nut located on the counter reset knob is unscrewed. The washer is also removed, the handle is pushed into the space behind the dashboard.
- With a thin screwdriver or a pike, pry off and remove the plug of the screw securing the dashboard.
- The main screwdriver is unscrewed with a Phillips screwdriver.
- The trim on the VAZ-2107 torpedo and the panel itself are carefully dismantled.
- The speedometer drive cable is disconnected, as well as the three-color wiring harnesses.
At the final stage, the panel is removed, after which it is possible to replace the backlight, indicator lights, and other elements. The part is installed in the reverse order.
Modernization
Tuning a VAZ-2107 torpedo allows you to fundamentally change the equipment of the passenger compartment. In the modern market you can easily find all the necessary parts and accessories. First of all, the owners change the main backlight. This solution allows you to improve the appearance of the torpedo and ease the load on the eyesight.
There are a number of other improvements, in the implementation of which a significant role is played by the correct technical approach and the owner’s imagination. Alternatively, you can mount white or multi-colored instrument scales that look non-standard, giving the design a completely new style.
It will be useful to replace the radio with a new and modern audio system. Fortunately, there are a great many modifications, which facilitates the choice, taking into account the capabilities and wishes of the user. Better tuning is best left to specialists. Nevertheless, the do-it-yourself VAZ-2107 torpedo can also be really improved without significant financial costs.
What do the owners think?
Consumers note that the dashboard on the machine in question is equipped with all the necessary minimum devices and buttons required to monitor and control the main systems. Nevertheless, the owners complain about the plain design details, as well as poor lighting.
The VAZ-2107 torpedo, the reviews of which are highly controversial, was developed taking into account new trends in the automotive industry. However, she lacks a modern design and sophisticated functionality. There is nothing surprising. Still, this car belongs to the budget category.
What torpedo is suitable for the VAZ-2107?
Many owners are not satisfied with the dashboard of the Seven. In the first modifications, a variation was established that was almost identical to the fifth model. In this case, the inconvenience is caused not only by the aesthetic appearance of the torpedo, but also by a practical problem. The glove compartment lock has to be fixed with the help of improvised means, since it constantly opens.
To replace the dashboard, an analogue from the VAZ-2115 is perfect. The only problem during installation will be the appearance of gaps, which can be carefully sealed with mounting foam.
A torpedo on a VAZ-2107 from a foreign car can also be installed. The best option is considered a part with a "BMW E30". In addition, an analogue of the Toyota Camry is often used. In this case, you will need to slightly trim the part on the sides, install power windows and correctly select the cover on the steering wheel.
Neon lights
Often when upgrading the Lada interior, users recall the LED backlight. It gives the interior originality, is easy to install and does not require large expenses. To equip the panel, you need a dozen LEDs that are interconnected by means of a special loop. As a clamp, a piece of wire with a Molex connector is used. In addition, a pair of 680 ohm resistors is required.
Installing a torpedo VAZ-2107 with new lighting will require compliance with several basic stages:
- First, the LED heads are cut with a file. After that, the entire surface is sanded, which will allow for a more uniform and soft glow.
- Next, the prepared wire is cut into pieces by half a centimeter and bent in the form of the letter "G". The form of placing new lighting is selected (in a circle, in corners or diametrically). The edges of the wiring are neatly soldered in the right place.
- The next step is to attach each leg of the LED by soldering. This makes it possible to regulate the on and off of the backlight directly from the control unit, directing the glow in the desired direction.
- Next, you need to cut the cable by cleaning the LEDs. This will allow you to form the main wiring, consisting of four main elements located around a large fixture. With lateral counterparts, they are soldered by means of several small wires. The result is a single chain. The minus and plus of the system is taken from the old design.
- In the end, you need to adjust the brightness of the glow. This can be done using the adjustment knob. This parameter is adjusted in a pair of circuits equipped with four central diodes.
The installation of a torpedo VAZ-2107 in a similar way makes it possible to move on roads, but with special care.
Instrument shooters
Improving the backlighting of arrows will require certain tools. For this you need:
- Two pairs of white LED lamps 3 mm long.
- Resistance resistors of 1.5 ohms.
- Plexiglass elements 4 mm long.
- Special paint or nail polish.
- Safety caps for arrow housing and plugs.
- Good (universal) glue, scales and wires.
Next, you need to determine the length of the arrow. If you take a size of 30 mm, then it is necessary to add a margin to the fixing space. When turning an element from plexiglass, it is necessary to observe the configuration of the arrow, providing an even base and a pointed edge. This will allow for optimal highlighting and even distribution of energy.
The opposite edge of the arrow grinds at an angle of 45 degrees. The element is varnished, preferably red, and secured to the panel with a furniture plug, put on glue. Then, the full-time arrow and the finished home-made analogue are weighed. If the readings exceed the difference of 100 milligrams, the part is brought to the required parameters. White scales and LEDs are inserted into the dashboard. This process requires special attention and accuracy. New bulbs on the sides are tinted with black paint, which will reduce light losses. Next, the LEDs are fixed to the scale and the devices are tested.
Total
As practice shows and reviews of the owners confirm that the interior of the Zhiguli can be improved without significant costs. For example, a torpedo from BMW on the VAZ-2107 allows you to upgrade not only the appearance of the panel, but also its functionality. The details of the improvement were noted above. We hope that the tips will not be useless, but will improve your car, regardless of the year of release and general characteristics.