If you are interested in the question of whether it is possible to glue vinyl wallpaper with non-woven glue, then you are probably going to make repairs. This question is quite common today. In order to understand the topic, you need to know that the glue is made on the basis of modified starch. Additives can have different properties, which affect the characteristics of the final product.
Is it possible to use non-woven adhesive for vinyl-based wallpapers?
If you are also interested in the question of whether it is possible to glue vinyl wallpapers with non-woven glue, then you can safely proceed to work. After all, the answer is yes. There is no fundamental difference between the mentioned types of glue. The only feature is the type and amount of additives.
If the manufacturer recommends using a specific adhesive, then it should be 100% suitable for certain tasks. However, you can use a different composition. So, if you purchased paper wallpaper, you can use non-woven glue. However, it must be made more fluid.
Instructions for working with vinyl wallpaper: preparation
The effect of the room will depend on how well you paste the walls. Even if the coating is beautiful and expensive, the interior may be hopelessly damaged.
In order that time and energy were not wasted, you must follow the instructions. It provides for the need to remove old wallpaper. It is recommended to do this with a narrow spatula. Pre-coating is wetted with water. If some scraps tightly stuck to the wall, you should use a special solution to remove wallpaper, but in this case you should work with gloves.
Wall preparation
After you figure out whether it is possible to glue vinyl wallpaper with non-woven glue, you should check the walls, which should be clean, dry and without cracks. If defects were found, they must be covered with putty.
The surface should absorb moisture normally. To verify this characteristic, the wall must be sprayed with water. If the droplets remain on the surface, then the absorption is reduced. In this case, the surface is peeled off with paper under the wallpaper.
If the spray formed dark spots and remained on the wall, then the absorption is too high. In order to eliminate problems, it is necessary to apply a paste, a primer or wallpaper glue.
Glue preparation
When you are no longer wondering whether it is possible to glue vinyl wallpapers with non-woven glue, you can proceed to pasting the walls. At the next stage, the technology involves the preparation of glue. The composition must have a special purpose. In order to properly prepare the mixture, continuously stir the water in the container, filling the contents of the package.
The resulting mass is stirred until a homogeneous composition is formed. Now you can proceed to the preparation of wallpaper. They are cut into pieces with a margin of 5 cm. Using a plumb line vertically on the wall, you need to draw a line, you will be guided by it when gluing the first canvas.
Tips and tricks for wallpapering
Quite often you can hear the question of whether it is possible to glue vinyl wallpaper on a paper basis with non-woven glue. Now you know that the answer is yes. However, all the rules for the use of such formulations should be observed. If the walls and wallpapers have been prepared, you can also apply a primer, which will help to glue the finish to the surface even more reliably.
After that, the canvas is smeared with glue and left for a few minutes, then you can begin to paste wallpaper on the wall. Sometimes experts recommend applying the composition only on the treated surface. You can familiarize yourself with the instructions for a specific material by looking at the packaging.
Vinyl wallpapers are glued back to back, the panels should not go on top of each other. It is important to remember that when sticking the material stretches a lot. You should try to combine the pattern while cutting the canvas. Part of the material will be in the waste. Short pieces can be used for pasting surfaces under and above windows. You can apply the leftovers for subsequent repairs.
If you are interested in how to glue paper-based vinyl wallpapers with non-woven glue, then you should know that polyvinyl chloride acts as the top layer for such a coating. It is responsible for moisture resistance. This suggests that the walls after repair can be washed even with the use of special tools.
Adhesive recommendations
For vinyl wallpapers, it is important to choose the right glue, which should fix the canvas on the wall rather quickly, but not instantly. This will allow you to fit the stripes at the joints and align them horizontally and vertically. Glue should exclude the development of fungus and mold. This is extremely important. After all, vinyl is poorly breathable, as a result of which microorganisms appear under the coating layer.
The consumption of a particular type of glue can be found in the instructions or on the packaging. It should not be assumed that with an increase in the amount of glue, you will ensure the best quality of the surface being trimmed. The mixture may leak through the seams and stain the surface of the canvas. If you have a question about how to properly glue vinyl wallpaper in a room on a non-woven basis, then you should also know that glue should not form clots or lumps. After all, they lead to bumps on the surface. You can store the prepared mixture for no more than a day. But in closed form, the composition can be stored for several years.
Wide Wallpaper Guidelines
The method of pasting walls with wide wallpapers does not differ from the technology, which involves the use of standard paintings. Wide should begin to be glued from the middle and from the top. If unevenness is still revealed, then a small cut should be made from the edge and the edges on the wall should be overlapped. If you purchased meter-long sheets, then it is better to use two stepladders, since such an approach can ensure good leveling of the strips. And your assistant will not have to move additionally.
If you are faced with the problem of how to properly glue wide vinyl wallpapers on a non-woven basis, then you should first determine the length of the wall in order to calculate the number of whole stripes. Starting from the window, you will need to mark the first canvas. Then you need to move deep into the room. Stepping back from a corner of 105 cm, you will have to draw a vertical line to the floor. It is recommended to use a plumb line and a pencil.
If the corner has an irregular shape, then you need to leave about 2 cm of stock. In the process, you will certainly decide on how to properly glue wide non-woven vinyl wallpapers in the corners. This stage needs special attention. Experts recommend leaving a lap on the corner, because otherwise a gap may remain on the wall.
You will need to glue the prepared canvas so that a narrow strip comes into contact with another wall. Excess wallpaper must be cut with a sharp knife, and it is recommended to walk the brush again along the edge of the canvas, pressing the material against the wall.
If blisters have formed, and the vertical edge that comes onto the adjacent wall has not been glued tightly to the wall, incisions are made on it obliquely. After that, the material is pressed again. At the very top of the corner you will need to hold a sharp knife to cut off the remnants of the wallpaper.