With the onset of cold weather, the question arises of how to insulate windows? Often they do not close very tightly, and as a result, dust gets into the room, as well as drafts. Depending on what kind of windows you have in your house, you need to choose a suitable insulation. For wooden windows, foam strips from 3 mm thick are perfect. They must be glued around the perimeter of the frame, except for the side on which the loops are located. Before gluing, it is advisable to rub the frame a little with sandpaper for roughness. It is necessary to begin to compact from the outside, and then the inside. In case of repair or painting, foam strips must be removed and the surface treated with a solvent.
How to insulate windows with metal strips?
For insulation, you can use special metal strips (strips) of stainless steel. Such strips are very durable and flexible. They are attached using cadded cloves. Before attaching the strip must be cut to obtain the desired length. At the junction of the strips, they overlap each other by about 3mm. The edged side of the strip should be located below, and a narrow edging at a distance of about 1 mm from the scar. Carnations need to be beaten at a distance of 3cm from each other.
How to insulate windows with putty?
In order to preserve the heat in the house as much as possible, a putty for glasses plays a special role, which ensures their best fixing. To cook it, you need to mix 15 g of linseed oil with 80 g of ground chalk and roll out with a wooden rolling pin until smooth. Put the resulting putty gently on the frame, wait until it dries, and then cover it with waterproof varnish. Putty should be checked periodically, and if it is cracked, remove with a knife and then apply a new one. Putty can be stored for a long time in oiled paper or under water.
How to insulate plastic windows?
Most often they are tight enough, but there are situations when they still need to be insulated. This can be a factory defect, poor-quality installation, the occurrence of deformation under the influence of severe cold. Before proceeding with the insulation of such windows, it is necessary to find the places of deformation, check and, if necessary, replace the hinges and latches. Then you need to wash the window and wipe it with a dry cloth so that it is not dirty and the insulation materials are well fixed. Fill the gaps with silicone sealant and a construction gun. Stick on, without tightening, a special sealing tape suitable for your window (for example, tape type D is designed to seal cracks from 3 to 7 mm). Then it is necessary to cut a special heat-saving film to the window dimensions , which transmits light and retains heat, and attach it with double-sided tape to the window frame, and then further strengthen it with the buttons.
How to insulate windows with your own hands using drywall?
First of all, it is necessary to pay attention to the outside of the window and cover the cracks with tile adhesive or concrete mortar. Then you need to do the cracks from the side of the room. To do this, prepare the work surface so that it is even. Using pliers, remove the excess layer of foam concrete, if necessary, clean the wall of excess concrete and plaster. Identify and cut blanks to fit the sides and top of the window frame. Attach the resulting sheets of drywall with screws to the wall. The remaining cracks must be covered with a putty, and when it dries, wipe with fine-grained emery paper, wipe from dust, and then paint.
How to insulate windows, which method suits you best, you can decide for yourself, using the provided tips.