Ippon Back Comfo Pro 800 is used for workstations and personal computers. Protects them from power surges and other disturbances arising in the power supply network. It has a Green Power function, which helps to save data and warns the equipment from problems associated with a sharp outage.
Machine description
The Ippon Back Comfo Pro 800 has a stylish and modern design. It is used for computers, both personal and peripheral, as well as for graphic stations and computers. Use a device for telecommunication equipment. It ensures the smooth operation of electronic devices. Protects them from data loss.
The IHD front panel is equipped with a power switch button. On the right is the device malfunction indicator, which notifies you when the battery is completely discharged or if you need to replace the battery. In these cases, the LED lights up in red. To the left of the power button is an indicator that indicates how the device works: from the network (green light) or from the battery (LED blinks green).
The top panel of the besperebnik is equipped with a convenient handle for carrying the device. Behind it there are four outputs responsible for filtering voltage surges. Below are two more outlets for Euro outlets. They not only protect against fluctuations in the electrical network, but are also able to provide electrical equipment with backup power. Even lower are the connectors that protect the modem and telephone lines from voltage surges. At the very end of the top panel of the device there are clamps securing the cable.
The back panel of the Comfo Pro 800 has an output for an electric power cable. To the left are COM and USB ports. Near the ports there is a device circuit breaker.
Device Options
Ippon Back Comfo Pro 800 is sold at retail outlets as follows. It:
- uninterrupted power supply;
- user manual for the operation of the device;
- warranty card;
- CD-ROM on which Russified software is located;
- set of cords.
The software located on the CD displays data such as frequency, voltage, battery charge. Shows the level of load on the device and other parameters.
The set of cords includes:
- cable for connecting to the mains;
- two wires with IEC 320 connector for connecting electrical devices;
- cord for connecting to a personal computer in RS-232 format;
- a wire for communication with a PC with a USB AB connector;
- telephone cable.
From the user guide you can find the addresses of service centers located in 48 cities of Russia. The warranty on the device is given for 1-2 years.
Charging device
Ippon Back Comfo Pro 800 comes with a built-in battery, which is fully charged at the time of sale. Despite this, the device may discharge during transportation. In this case, it will need to be charged. For this, the uninterruptible power supply is connected to the mains and left for eight hours or more. When charging the UPS, do not connect any other equipment to it.
Before connecting the Ippon Back Comfo Pro 800 (black new) to the mains, make sure that the mains voltage is fully rated, which is 220 V. The mains power cord is connected to the device on one side and to a power outlet on the other. All devices are connected in accordance with the connectors located on the top panel of the uninterruptible power supply, using appropriate wires for this.
The telephone and modem cable are connected to the input connector of the device located in the upper part. In order for the operating system to automatically shut down, you should dock the computer and the UPS through the RS0232 or USB ports.
Uninterrupted operation
Ippon Back Comfo Pro 800 (the instructions describe in detail all the nuances of using the device), the first time it starts, it starts in automatic mode. To turn it off, click on the appropriate button. This should be used to restart the device in work.
If the device is not connected to the network, then you can use the “cold” start function. With its help, the device protects electrical equipment by supplying power directly from the battery. To start it, just click on the button to turn on the UPS.
The uninterruptible power supply has a Green Power mode, which, in the absence of electric voltage, will automatically turn off the device if no load is connected to it.
If the battery becomes unusable, it should be replaced. To do this, unscrew the screws located at the bottom of the device and press down a little. After that, remove the front cover and remove the battery, unscrewing the wires that connect it to the bespereberenik. By analogy, they insert a new battery and start the device in operation.
The UPS comes with the disk where WinPower 2004 is located. To install it, insert the disk into the computer and follow the recommendations that appear on the screen.
Instrument Technical Features
The Ippon Back Comfo Pro 800 (New) UPS is rated at 800 VA / 480 W. The voltage of the device at the output and input is 220 V. The range of possible voltage deviations varies from 162 V to 268 V.
The device has a sealed lead battery consisting of six elements. It can work in standby mode from 5 to 30 minutes. Time depends on the load of the device. The device charges 90% in eight hours.
Comfo Pro 800 is equipped with a sound alert. So, in standby mode, he emits rare beeps, once every ten seconds. If the battery is low, sounds occur every second. When the device is overloaded, the notification sounds once every 0.5 seconds, and when the battery is damaged or discharged, the beep sounds once every two seconds. An uninterrupted failure is indicated by a continuous beep.
The device has the following parameters:
- length - 300 mm;
- width - 124 mm;
- height - 210 mm.
The weight of the UPS is 6.4 kg. The device is compatible with all Windows and Linux operating systems.
Possible malfunctions
During operation of the device, various malfunctions periodically occur. So, for example, the green indicator on the front panel of the Ippon Back Comfo Pro 800 may not light up - the battery built into the device is faulty or missing. Another similar situation occurs when the device is turned off. A dead battery should be replaced with a new one. If the battery is missing, it must be inserted.
If the power coming from the mains is within normal limits, and the device emits a continuous beep, this indicates an overload of the UPS. In this case, you should make sure that the load on the device corresponds to its technical capabilities.
If the battery discharges quickly enough during a power outage, this indicates a device overload, a low charge level or a battery malfunction. In the first case, all secondary loads are removed from the uninterruptible system. If the battery is low, it needs to be charged. If the battery malfunctions, it must be replaced with a new one.
Interior fittings
The Ups Ippon Back Comfo Pro 800 has an NPW 45-12 brand battery . The battery capacity of the device is 9 Ah, and the operating voltage fluctuates around 12 V. This battery is characterized by an increased 75% return with a 10-minute discharge.
The internal design of the device is traditionally done. In the lower part of the device there is a transformer and a battery, and its upper part is reserved for the electronics plateau.
The main part of the electronics is on a single-layer board, where PCB of decent quality is used. Installation of elements on the board is quite satisfactory, all details are signed. The sockets located in the upper part of the device interface with the electronic board through special connectors. There is a protective unit RJ-11, which works offline and only for the central core.
Surge protection is carried out using a varistor. The windings are switched through a relay. The highest switching current per one relay is 7A, but in the case when the electric voltage is 270 V. This feature of the device allows you to connect a load with a capacity of up to 1800 VA. The inverter runs on four transistors. Creates an approximated sine wave. On an area of 120 square meters. see in a common radiator power transistors are located. They are connected to the radiator by gaskets and secured with screws. Each of them is characterized by a power of 100 W, a scale of operating temperatures reaching 175 ° C and a voltage of 30 V.
The unit responsible for adjusting the output voltage (AVR) was created using an autotransformer circuit. In the uninterruptible system, a transformer on a W-shaped core with one autotransformation stage is used.
Positive aspects of the device
Ippon Back Comfo Pro 800 (black) can be used at home. Among its advantages, users distinguish:
- stabilization of the output voltage, which affects the entire range of loads;
- stylish and modern design;
- full set, which includes a set of cords and software;
- one year warranty: not only on the product, but also on the battery;
- Russified program to the device;
- USB and RS 232 ports for connecting to a PC;
- sound notification about the status of the device;
- light indication of battery status;
- protection against short circuit and various overloads;
- the “cold start” function, which allows you to start the equipment in the absence of voltage;
- Euro sockets;
- microprocessor control.
These and other advantages of the device distinguish it from the rest. Indicate good quality and decent specifications.
Minuses
Among the shortcomings of the Ippon Back Comfo Pro 800 UPS are an unregulated power saving mode, lack of Smart Battery support and an uncomfortable charging circuit. In some cases, users indicate strong heating of the case and a small number of Euro outlets.
Comparison with competitors, the best uninterrupted
Ippon Back Comfo Pro 800 fully justifies all the functions announced by the manufacturer, but the market does not stand still, and competitors are trying to create something new, more advanced. So, according to most users, the best UPSs are:
- APC by Schneider Electric Smart-UPS 1000VA. There is an audible alarm and an LCD display that the Ippon Comfo Pro 800 does not have. Output power is 650 watts. There are eight connectors for connecting to a PC. The battery is fully charged in three hours, unlike the Comfo Pro 800, in which the battery charges for 8 or more hours. At full load in standby mode it works for 6 minutes, and at half - 20 minutes. It costs more than Ippon, about 30 thousand rubles.
- Inelt Smart Station Power 1500. The output power is 900 watts. There is a cold start mode. The battery charges 100% in 12 hours. Able to protect not only the local network, but also the telephone line. Blocks the effect of high voltage pulses. Comfo Pro 800 does not have this function. It costs around ten thousand rubles.
- IPPON Smart Winner 1000. The output power of the device is 650 watts. Working time in standby mode at full load is 5 minutes. The parameters of the device allow it to be mounted in a 19-inch rack. The device is fully charged in three hours. It costs a little more than Comfo Pro 800, about 11-14 thousand rubles.
- Ippon Back Comfo Pro 800 New. It has an output power of 420 watts, a cold start function. It has eight euro sockets, unlike the Comfo Pro 800, which has two of them. The device protects the local and telephone network from all kinds of interference and high-voltage pulses. It costs Ippon Back Comfo Pro 800 New 5000 rubles .
- FSP Group EP 1000. Output power - 600 watts. There is a sound notification and light indication. It has four sockets for connecting a PC. The battery charges in 6 hours. The device protects electrical equipment from short circuit and interference on the power line. The device costs about 4 thousand rubles.
- IPPON Smart Power Pro 1400. The output power of the device is 1400 VA. It takes 4 hours to charge the battery. There are LED indicators and sound alerts. The device has 4 euro sockets. It costs about 10,000 rubles.
A good UPS will protect your computer and other equipment from interference on the line. Devices “more expensive” are considered more reliable, have more extensive functionality, work in standby mode longer and have a longer service life.
Cost
The price of the Ippon Comfo Pro 800 ranges from 5,000 to 7,000 rubles. The cost depends on the margin in the distribution network. The color of the device does not affect its price.
Where can I buy?
UPS Ippon Back Comfo Pro 800 (black) can be found in stores of computer and household appliances, such as Eldorado, Computer Market, Citylink, DNS and others. This product can be purchased online.
Device Reviews
Ippon Comfo Pro 800 reviews have a variety of different. Some are completely satisfied with this device, note its stylish design, excellent build quality, equipment, including the presence of all the necessary wires. The users like the convenient carrying handle and special clamps designed to fix the wires, as well as the availability of euro sockets. These people say that the device works stably, quietly, and is very good at its tasks. When turning off the light with a load, it holds about 10 minutes.
Negative opinions indicate that the device is very hot, has an unstable output current. The software is poorly installed on the computer and does not detect an uninterruptible power supply. Even during operation, the UPS constantly clicks. There are those who say that the device does not cope with its functions, poorly stabilizes voltage and does not protect equipment from power surges.