Buying a new HDD or replacing the old one leads users to the question of how to remove the hard drive from the computer themselves. It will be necessary to remove it with extreme caution so that you can use it in the future and not cause physical damage to the mechanical parts. The slightest blow can lead to complete dysfunction of the hard drive.
It often happens that from one computer it is necessary to transfer data to another, but removable drives do not have such a memory capacity and data transfer speed. In this case, you have to rearrange the hard drive to another computer. If you follow the instructions, then removing the hard drive from the computer can turn into a normal routine.
What is the role of the hard drive and where is it located
Winchester is located inside the system unit, between two different types of drives. Sometimes above it are the slats of RAM.
The hard drive is designed to record and store information of long-term content. Very often, inexperienced users confuse the "hard" with RAM - and this is fundamentally wrong. The fact is that the RAM does not store information in itself, but processes and transfers it to the processor or to other parts of the system. The hard disk, in turn, can store all the information and record it an infinite number of times.
Types of Hard Drives
At the moment, two types of internal drives are popular - these are HDD and SSD. The first consists of mechanical parts, it can easily be damaged and it is inexpensive.
The second representative of data storage is solid state and consists of microcircuits, which enhances its shockproof functions. Its data transfer speed is much higher than that of a mechanical counterpart, but the cost is higher. In modern cases of the system unit provides a "slide" for connecting an SSD to the port of a regular hard drive.
Removing a hard drive
The first step in how to remove the hard drive from the computer will be a complete blackout of the system unit. To do this, just shut down and disconnect the system unit from the network.
After that, you need to unscrew the four bolts on the rear panel of the case. Sometimes it can be hinged fasteners instead of bolts.
Next, you need to open the system unit covers, which are located on the sides. Each must be gently pressed down and directed towards the rear panel. For these purposes, there are special recesses on the covers.
When there are no side covers, you can see all parts of the system unit, and the desired hard drive is located in front.
The next step, how to remove the hard drive from the computer, will be the disconnection of two cables-loops. One of them supplies power to the hard drive, and the other is responsible for data transfer.
When the cables are disconnected, you can proceed to loosen the screws. They are usually twisted in two pieces, on the sides. After that, you can safely remove the drive from the system, pulling it towards the rear panel.
How to rearrange a computer hard drive
Changing the place of work of a hard disk is no less an important task than removing it. It was previously described how to remove a hard drive from a computer, but now you have to figure out how to rearrange it to another port. This may be necessary for several reasons, and one of them is interface support. The fact is that each interface has a different data transfer speed, so users may want to increase the data transfer speed in the system by changing the "socket".
Mounting the hard drive is the same as removing the "hard", only in the reverse order. To test the ability of the system to recognize a new device, you must first install the disk. After that, go into the BIOS settings and see this device in a specific tab. Then, after starting the system, go to the task manager and see its presence in the "Controllers" tab.