Short-stroke backstage for VAZ-Priora cars

For a more precise gearbox shift, a short-stroke drawstring with sequential gear is used. Since the course of such a backstage is somewhat smaller, the switching is faster and more convenient. This short-stroke backstage is suitable for those who like a fast ride. It is also necessary for those who are interested in reaction and a clear gear shift.

short stroke backstage

Korotkohodnaya drawstring is made of high strength material. Its distinctive features are wear resistance and reliability.

Priora short-stroke

To install it, remove the gearshift lever cover and knob. To remove the knob, it is enough to make some effort and pull it off, since it does not have fastenings. Now you need to loosen the clamp and remove the gearshift link rod from the cardan. For this operation, you need a key at 13. To remove the lever, you need to release the ball from the spring mechanism (it is needed to engage reverse gear with a lock). For this purpose we remove a lock ring. Never pull on the lever. It is necessary to remove the retaining ring and lever with a ball inserted in a plastic frame and spring.

The plastic frame is presented in two parts - the upper cylindrical part and the lower. The upper part with the slit should be put on the lever, and the ball should be inserted into the lower part. The top should grab the bottom, while it is necessary that the grooves coincide. This design must be fully supported on the lever. Now through the cabin you can remove the lever with traction.

The next step is to remove the universal joint. To do this, you need to tighten the rubber boot and unscrew the key on the 10 left bolt on the cardan with a key. The cardan from Priora differs from the viburnum cardan by the length of the stem. Short-stroke scenes, depending on their type, may require shortening the stock from Kalina. If shortening of the stem is required, it should be remembered that sawing should be no more than 1.5 cm. Before installing the universal joint from Kalina, a small layer of lithol should be applied. Now you should screw in the bolt, but there is no need to tighten it.

Through the interior of the car we insert traction. For this operation, an assistant will be required: one person will hold the gum through which the draft passes in the cabin, and the second pulls it gently.

Now you can start assembling. For this:

Priora short-stroke

  • pull the rod onto the universal joint rod;

  • assemble the lever spring mechanism. Be sure to grease the ball with lithol;

  • set the lever in a convenient position, that is, center;

  • tighten the clamp on the rod.

If the first time it was not possible to center the lever, then you should repeat the last two steps.

One more tip: if you first assemble the spring mechanism, it may not be possible to put traction on the cardan rod due to its length. This problem can be eliminated if the cardan is shortened. Do not forget to put on the boot.

The last step you need to do is adjust the lock mechanism.

short-stroke backstage vaz
reverse gear. A short-stroke drawstring may require blocking during fitting - this is if the mechanism does not match the plate for which it clings. To do this, you need to remove the plate and adjust the engagement of the mounting bracket of the plate having a cutout. For this bracket, the mechanism is engaged. Sometimes it is necessary to modify the plastic hook with a file.

Now you can put on the gearshift lever cover and knob.

Such a short-stroke backstage VAZ is suitable for those who like to drive fast, for those who need reaction and a clear gear shift.


All Articles