How to pump the clutch on the Niva? This question excites many car owners. Clutch bleeding on the Niva car is made in the presence of air in a hydraulic actuator. Fortunately, this problem does not occur often. Sealing failure occurs due to wear and various damage during the repair process. Pumping is also carried out when replacing fluid and clutch parts.
Signs of air in the system
The following signs indicate the presence of air in the hydraulic drive: when you press the pedal, the clutch does not turn off completely, when you turn off the reverse speed, a characteristic rattle is heard. To work, you will need a tool kit, a small container, a hose and brake fluid. This procedure is practically no different from bleeding the brake system. Therefore, even a novice motorist will cope with it. Use fluid recommended by the vehicle manufacturer.
Sequencing
How to pump the clutch on the Niva? Clutch hydraulic repair is best done on a flyover. First, check the hydraulic elements for smudges. Then the fluid level in the tank is checked. It is located in the engine compartment. If necessary, add fluid. In this case, garbage and other impurities should not get into the tank. Then carry out the adjustment of the clutch. Only after this can pumping begin. An assistant is needed for this work. In its absence, a gas stop is necessary to fix the clutch pedal. The protective cap is removed from the union of the working cylinder. Then they put on one of the ends of a transparent silicone hose. Its other end is lowered into a container with brake fluid. The tightening of the fitting is loosened by a few turns with the “eight” key. After that, air starts to escape from the hose along with the liquid.
The assistant sits behind the wheel, sharply presses the clutch pedal several times and releases it. The interval between clicks is approximately 3 seconds. This action stops only when liquid without air bubbles flows out of the hose. Then, fluid is added to the clutch reservoir. With the pedal depressed, wrap the fitting and put on the cap. After that, check the clutch system. When operating the gearbox, no abnormal sounds should be heard. At high speeds, the car should dynamically accelerate. This completes the repair.
Advice
When moving the car, do not constantly keep your foot on the clutch pedal. The disk and other elements of the clutch system will wear out and slip faster.