Non-woven wallpaper is very popular today. For example, everyone knows vinyl products, which are characterized by a wide variety of combinations of colors and patterns. The basis of such wallpaper is non-woven. With proper vinyl spraying, the material retains the ability to let air through. And he can have a beautiful relief that will make the room original and cozy.
Non-woven wallpapers have a lot of advantages. For example, some types of material can be painted in any color, so you can quickly refresh the room without removing the glued finish. Naturally, the repair time is significantly reduced. When gluing such wallpaper there is no need to apply the substance to the material itself. You just need to spread them a wall. In some cases, the thick base of the wallpaper can eliminate small bumps and defects on the base surface. And they can also be glued in technical rooms. The fact is that non-woven wallpaper is not subject to moisture, does not swell and does not exfoliate. Therefore, you can use them to repair the bathroom or kitchen. In addition, the base of the wallpaper is very strong, as it is made of cellulose fibers.
Very popular are non-woven Rasch wallpapers. They stand out for their superior quality, enhanced safety and aesthetics. The presented material is manufactured using the most modern technologies. A lot of specialists work on creating the design of each wallpaper model.
The material presented is very practical, but it must be properly glued. Working with him is not so difficult if you know some of the nuances. Once again, it should be repeated that gluing wallpaper on a non-woven basis should be on a prepared basis. The painting itself is not worth smearing. Glue must be diluted strictly according to the instructions, in addition, you should choose the right substance for this type of material.
During operation, be very careful that the glue does not get on the picture of the paintings. You can start the gluing procedure from any angle. The fact is that the joints should be joined end-to-end. The very first strip should be attached as evenly as possible. In the corners often have to glue the canvas overlap. However, it should be optimal so that the edges of the strips do not bulge. If wrinkles still appear on the treated surface, then the wallpaper needs to be cut and smoothed.
Pasting wallpaper on a non-woven basis with a volumetric pattern requires alignment with a soft roller. The sequence of work is very simple. First, we cut the canvas of the required length from the roll, then we smear the wall with glue and apply a strip to the surface. Using a roller or rubber spatula, tightly but carefully smooth the wallpaper. And we do this so that the excess glue comes out in the direction where the strip is not yet attached. In this way, we carry out the entire procedure. That's all the features of working with non-woven wallpaper.