Unfortunately, there is nothing eternal in the world, and sooner or later every car has to be tinted. If a scratch on the machine appeared due to an accident, hooligan actions or careless operation, do not run to the service center and order expensive painting services. You can eliminate the deformation on the body yourself, the main thing is to have a desire and a minimal set of tools. And today's article will help you deal with this problem.
Preparatory process
Having learned how to fix a scratch on a machine, we first need to prepare the damaged surface for painting. To do this, thoroughly rinse the body and degrease it. If rust has appeared on the surface of the metal, remove it with sandpaper. At the same time, do not process factory paint that has been preserved near the scratch. After all these procedures, you can begin to work.
Instructions for repairing paint defects
First we need to put putty on the body. If the scratch on the machine is slight, use a two-component polyester material. After the putty is applied to the surface of the body, we carefully level it. While it dries (about 10-15 minutes), take a rubber spatula and carefully level the surface. Excess putty must be removed from the surface. To keep the excess as little as possible, apply the material with extreme care, with a thin layer.
After the putty dries, the scratch on the machine will no longer be visible. But our work does not end there. Next we need to sand the surface. This is done so that there are no visible irregularities and roughnesses on the body. How to wipe scratches on a car? To achieve the desired result, use coarse sandpaper. Then we turn to fine-grained. Sanding to the point where there are no rough sections, pits and tubercles on the body. To determine the quality of the work done, just hold your palm on the surface of the metal.
At this stage, you can proceed to the priming. It is best to purchase a special aerosol spray. We apply the soil in one layer without the use of sandpaper.
Now we pass to the most crucial stage - painting. So that later there are no visible spots on the body, select only those shades that correspond to the factory values. To do this, find out the exact paint number. It is listed in a special brochure supplied by the vehicle manufacturer. Spray the aerosol at a distance of 20-30 centimeters from the body, so that there are no streaks and spots. We apply the paint in three layers with a frequency of 7-10 minutes. After that, the scratch on the machine will be permanently fixed. After performing these works, it is advisable to treat the car body with varnish and carefully polish it.
After reading this article, you once again made sure that body deformations are not always necessary to be eliminated in a professional technical center with the use of expensive equipment and tools.