Fishing is a vacation for the soul. And today we’ll talk about how to make an elastic band for fishing. Let's start with the sinker. Its weight should be selected so that it does not slip when pulling the trophy, as well as throughout the day. The peculiarity of the gear we are considering is that casting should occur farther than that of a conventional donkey, at least by the length of the gum itself. For this reason, fishing for gum, as a rule, involves a swim in the right place along with the cargo yourself or on a boat.
Fishing with a rubber band
For convenience, you can hang a thick rope, on which the float clings. At the end of fishing, a sinker can be pulled out for it. It will be useful to additionally lighten the place where the gum itself joins the fishing line. He will press the latter to the ground and will not allow her to walk freely along the height of a river or lake.
We continue our topic about what is an elastic band for fishing, how to make it and how to catch it. Next, we select the length and size of the rubber. The latter is square and round. It is better to give preference to a square variety, since in a round one there is a very high probability of marriage, namely the presence of air bubbles in which it very often bursts, and this always happens at the wrong time.
Length calculation
So, we have determined, best of all - a square elastic band for fishing. How to make it fit long? Take ten centimeters of this material as a sample and stretch it until a break occurs. Next, we determine the coefficient of stretching. If before the cliff, the length of your gum was seventy centimeters, this means that it is one in seven. To eliminate the gap during fishing, as well as to prevent our gum from being too tight, slightly lower the value, for example, to one in five.
After we have decided what stretching coefficient our fishing gum has, how to make it the necessary length, it will be easy to guess. For example, if it is necessary that the hooks extend forty meters from the coast, the length of the elastic should be eight meters.
So that the tackle does not escape from your hands and does not hurt you with hooks, drive a strong stick into the ground, the top of which must be split with a knife. During the stretch, bring the fishing line into this split and make several revolutions around this stick, then put it back into the split. Now there is nothing to worry about. Take your catch quietly and hook the bait. After this, the fishing line is slowly removed from the stick and carefully, a little bit, is released back into the pond.
Summary
As for the choice of signaling device for bite, this is a personal matter of your taste. That's basically all that is an elastic band for fishing. How to make it, you now know. I would also like to add that this tackle is quite old. It is convenient in that it will be enough for you to bring it once to the necessary place, after which you will no longer need to reset it every time. However, if you want to change the place of fishing, then this advantage turns into a disadvantage, since in this case you will have to tinker, and quite a lot, but such a need does not arise too often.